39E Operating instructions
Page
4 / 8
──────────────────────────────────────────────────────────────
SW V1.01
11.09.2005
La Gard Latin America - 741 Shotgun Rd. – Sunrise Florida – 33351 – USA
Tel. +1 954 476 5574 – Fax. + 7 954 476 5576 – Email: info@lagardlat.com
Pre-setup mode
After factory reset lock enters pre-setup mode. Communication with lock using serial interface on TAG reader is
possible to test and setup the lock.
Into this mode, pressing key '1' activates solenoid, silent alarm and test remote input. Key '0' send power-upprompt
(request for PC Setup software). Other keys beep once.
Pre-setup mode cancelled by keeping down '0' key until double beep, and entering any valid code.
Special procedures
Setup process, to do list
The following steps are necessary to setup the lock from the ground:
•
Factory reset. Configuration is reset to default.
•
Select code length (manager function #8). Choose how many digits for manager and users codes. Select
standard mode (without additional features).
•
Install users (manager function #1). Install all users you need with default codes. Deleted (or never installed)
users will not be available after manager changes his code.
•
Select additional features (manager function #8). Enter ‘0’ as code length to not modify it. Choose optional
features.
•
Freeze configuration (manager function #0). Manager changes his code to freeze configuration.
Lock is now fully operational.
Note that PC Setup software is able to set whole configuration using serial interface.
Factory reset procedure
Remove battery.
Hold down key ‘0’ during 10s to discharge all internal capacitors.
Connect Reset Box to alarm box connector.
Put the battery back in place, factory reset is completed.
Disconnect Reset Box.
Lock configuration is: 6 digits code, only manager code exists, set to all ‘5’. Audit file not cleared.
Lock will be operational as soon as manager changes his code.