10. Remove the mounting screw from the system card, and
gently lift the system card out of the case. (Figure 12)
11. Insert the spindle through the spindle hole in the front of
the
door.
12. With the bolt retracted, carefully thread (clockwise) the
spindle into the drive cam of the lock assembly
until
tight.
13. Next, rotate (counterclockwise) at least 1/2 turn until the
groove in the spindle is aligned with the correct spline
position. The correct spline position for the installation
orientation showing in Figure 12 is RH (for a “Right
Hand” door.) Refer to the following
Spline Key
Position
Chart
for all mounting positions.
Spline Key Position Chart
The lock may be mounted in four positions - align the spindle groove with the
corresponding cam position. The positions are
•
RH
(right hand)
Lock bolt points right as you view the lock from the back side of the door.
•
LH
(left hand)
Lock bolt points left as you view the lock from the back side of the door.
•
VU
(vertical up)
Lock
bolt
points
upward.
•
VD
(vertical down)
Lock
bolt
points
downward.
14. Insert the spline key fully into the cam from the back of the lock assembly by tapping it into place.
Important Note:
Ensure the spline key is seated against the spindle.
15. Reinstall the system card.
16. Reconnect the solenoid (and bolt switch if applicable.)
17. Reinstall the back cover.
18. Connect the cable coming from the Entry Device directly into the connector port marked ENT on
the
lock.
Note:
Ensure the cable is secure and away from any moving parts.
BATTERY INSTALLATION
Caution:
Keep the container door open during battery installation.
1. Remove the battery compartment cover at the bottom of the entry device.
2. Connect a new 9-Volt Alkaline battery to the battery connector. Use of a high quality,
name brand battery (Energizer® or Duracell®) is recommended.
Note:
Once the battery is connected, the system will run a self check of the display
and buzzer.
3. Place the battery back in the battery compartment and put the cover back in place.
(P/N)738.098 Rev A • 04/09
© copyright 2009
Kaba Mas LLC
page 5 of 5
Cam
Figure 13
Bolt positions as viewed from the back of
the lock.
Figure 14
Mounting
Screws
Solenoid
Connector
Card and
Card Screw
Cam
Bolt
Switch
Cover
Screws
Figure 12
749 W. Short Street, Lexington, KY 40508 USA
Phone: (859) 253-4744 FAX: (859) 255-2655
Technical Support: (800) 950-4744
www.kaba-mas.com