Combogard 3040 Eng
LA GARD Locks BV
Revisie:
2
Vlijtstraat 40, NL-7005 BN DOETINCHEM
Datum:
13-09-02
Tel: +31 (0)314 376876 Fax: 378188
4. TO CHANGE THE CODE (by open door)
Enter 6 x "0"
(double signal)
000000
Example:
Enter valid code
(double signal)
123456
Enter new code
(double signal)
471147
Confirm new code
(double signal)
471147
The new code is now valid. If mistakes are made while changing the code or if
an interval occurs of more than 10 seconds, the old code remains valid and the
entire sequence has to be re-entered.
5. SAFETY ADVISE
•
Change the factory code immediately.
•
Do not use personal data (birth date) as a code.
•
Keep the code from unauthorised use.
6. POWER SUPPLY / BATTERY CHANGE
When the batteries are running low, the lock will signal for about 3 seconds
while being opened. The batteries then have to be changed. Use
ALKALINE
batteries only!
3035, 3075:
Open battery box (inside door) and insert new batteries.
If the batteries have not been changed in
time and the tension does not suffice to
cancel the lock‘s blocking feature, a new 9V
ALKALINE
battery can be pressed onto the
contacts on the entry, until the code has
been entered and the entry is rotated.
When Time Delay is programmed, use a
battery clip (on general sale).
Black upper position, red lower position.
3750: Open the battery compartment by lifting the plastic cover under the entry,
insert new batteries.
No battery change has to be performed when the SP-box is connected to
the alarm system.
The code remains active even as the power supply fails.
A) Manager Mode
The primary code (manager code) can add User code. The codes can be
changed independently (see: To change the code ").
1. Add second user:
Enter manager code (double signal) and hold down the last digit until the lock
double-signals again (approx. 2 seconds). Press "1" (double signal).
The user enters his code twice (two times double signal).
Î
Both manager code and second user code can now open the lock.
When the second code is not accepted (3x signal), it is to equal to the first code.
Select a new code.
2. Disable second user:
Enter manager code (double signal), hold down the last digit until the lock
double-signals again. Press "2" (single signal).
Î
Second user is disabled.
REINSTATE second user:
Enter manager code (double signal), hold down the last digit until the lock
double-signals again. Press "1" (single signal).
Î
Second user is reinstated.
3. Remove second user:
Enter manager code (double signal), hold down the last digit until the lock
double-signals again. Press "3" (single signal).
Î
Second user is permanently removed. A new second user code can be added
(see 1).
4. Test, if second user is added:
Enter manager code (double signal), hold down the last digit until the lock
double-signals again. Press "1".
Pay attention to the number of signals that follows:
1x signal:
A second user code is added and active.
2x signal:
A second user code can be added (by entering a code twice).
3x signal:
Manager Mode has not been factory-activated; no second user
can be added.
If the lock
does not
double-signal when the last digit is held down, the second
user code is entered instead of the manager code.
