(P/N) 731.018 Rev H 12/14 • © copyright 2008-2014
Kaba Mas LLC
page 9 of 11
SAVE SETUP CONFIGURATION
Once the setup configuration has been completed, you may name and save the setup file (*.xml) for future use.
1. Click the
Save button or on the Files tab at the top of the program and select Save (Figure 15).
2. Name the file and click the
Save button (Figure 16).
Figure 15
Figure 16
ACTIVATE THE LOCK
1. Press and hold the
0 key until the lock signals twice.
2. Enter any valid combination within 40 seconds.
The lock will signal twice then one long beep (approximately 2 seconds). The lock is now fully functional, but still in Setup. This
means the Manager still has the ability to change the lock configuration. To complete the activation and freeze the lock’s
configuration, the Manager combination MUST be changed. Prior to changing Manager Combination, SMR must be set up or it will
be lost. (Please refer to Page 2 of this document for SMR instructions.)
To change the Manager combination, follow the steps below:
CAUTION: Always perform this operation with the door open!
3. Enter the Manager combination and hold down the last digit until unit double signals twice release and the LED stays on.
4.
PRESS 0.
5. Enter the NEW combination.
6. Re-enter the NEW combination to confirm. The lock is now active and the configuration is frozen.
NOTE: To change the settings after the configuration has been frozen, the lock must first be reset. Refer to the Reset Lock section of
this document.
