4
Important information
Introducing your new cooker
We thank you and congratulate you on your choice.
This carefully designed product, manufactured with the highest
quality materials, has been carefully tested to satisfy all your
cooking demands.
We therefore request that you read and follow these easy
instructions which will allow you to obtain excellent results right
from the start.
This cooker is fitted with a gas cooktop featuring ‘one touch’
electronic ignition, flame failure safety cut-off to all cooktop
burners and a cooling fan. The programmable multi-function
electric oven contains a circulation fan, self cleaning oven linings
and a triple glazed oven door. The cooker is fitted either with
an upstand or a glass lid.
The cooker’s data plate is accessible even with the cooker fully
installed. It is positioned on the inside of the oven door, centre
bottom. A copy of the data plate is also reproduced on page
35 of this booklet. Always quote the details from it to identify
the appliance when ordering spare parts or requesting a service.
Notes on disposal
❍
Old appliances still have some residual value. An
environmentally friendly method of disposal will ensure that
valuable raw materials can be recovered and used again.
❍
Before you dispose of your old appliance, make sure that it
has been rendered inoperable.
❍
Your new cooker was protected by suitable packaging while
it was on its way to you. All materials used for this purpose
are environmentally friendly and suitable for recycling.
Please make a contribution to protecting the environment
by disposing of the packaging appropriately.
Before connecting your new cooker
❍
Before using your new cooker, please read these ‘Instructions
for Use’ carefully. They contain important information
concerning your personal safety as well as use and care of
the oven.
❍
Please keep the operating and installation instructions in a
safe place; this important documentation may also be of
use to a possible subsequent owner.
❍
Do not use the cooker if it is damaged in any way.
❍
Installation and connection of the cooker should be
performed according to the instructions and connection
diagram provided, and should be entrusted to a licensed
33
1. Remove cooker rear cover by unscrewing 7 phillips head
screws.
2. Disconnect electric wiring to the element at the rear of the
oven.
3. Remove the screw securing the element in position at the
front of the oven roof.
4. Undo 2 phillips head retaining screws securing the element
to the rear of the oven roof.
5. Replace element and reconnect wiring.
6. Reassemble in reverse order.
To replace bottom element
Pull cooker forwards to gain access to the rear of the cooker.
1. Remove cooker rear cover by unscrewing 7 phillips head
screws.
2. Disconnect electric wiring to the element at the rear of the
oven.
3. Lift off oven door as per heading ‘to remove oven door’.
4. Remove 2 phillips head screws securing oven floor at front.
5. Slide oven floor towards rear and lift to clear front flange
and remove.
6. Undo 2 phillips head screws securing element to oven rear
panel.
7. Replace element.
8. Reassemble in reverse order.
Final check
Check correct operation of each burner individually and in
combination. Burner flames should be clear blue, with no yellow
tipping. If the burners show any abnormality check that burner
heads are correctly located. If satisfactory performance can not
be obtained, contact Sampford & Staff or the local gas utility.
For service contact number refer page 9.
Summary of Contents for LUEP51-90-S
Page 35: ...Part no W1885 Revision D 2006...
