8
Electrical connection
The electric lead and plug are for connection onto a
15
Amp
socket. A
15
Amp socket is to be within 1 m of the appliance.
The lead is situated at the left hand side of the cooker.
Gas regulator
The gas connection is via 1/2” compression. Connect the cooker
to the gas supply and check for gas soundness.
If using a flexible connection
This appliance is approved for connection by a CLASS B hose.
Connection is in compliance with AS 5601, clause 5.12.1.8.
If using a copper connection
To allow cooker to be moved forward for service make a loop in
the copper tube before connecting onto regulator.
Gas connection
The cooker must connected to the gas supply with upstream
connection of an isolation valve in accordance with the
respectively valid regulations. We recommend that the isolation
valve be fitted prior to the cooker to enable isolation of the cooker
from gas supply. The valve must be easily accessible at all times.
To find out the factory set gas type, see label at rear of cooker.
The gas connection via 1/2” compression. Connect the cooker
to the gas supply and check for gas soundness. NEVER use a
naked flame to check for leaks.
Gas inlet position- Nat gas
Gas inlet position LP Gas
From RH rear side: 35 mm¢
From RH rear side: 35mm¢
Up from floor:
600 mm¢
Up from floor:
685mm¢
Gas inlet with different leg heights - mm
Min
NG: 585
LP: 670
Ref
NG: 600
LP: 685
Max
NG: 620
LP: 705
Electric & gas connection
29
To replace thermostat
Follow access procedure as per the heading ‘To replace gas
control valves’.
Please note that the thermostat has a fixed control - no adjustment
is necessary.
1. Remove the rear panel of the cooker by unscrewing 7 phillips
head retaining screws.
2. Unclip the 2 thermostat bulbs, one from the rear wall of the
oven and one from the top LHS wall. Pull the bulbs up through
the access hole in the rear panel of the oven.
3. Unclip the electronic connectors from the thermostat. Mark
the connectors so they are replaced in the correct position.
4. Using a phillips head screwdriver unscrew the 2 screws which
secure the thermostat to the fascia support plate remove the
oven thermostat.
5. Replace thermostat and secure to the fascia support plate
with the 2 clamping screws.
6. Feed the thermostat bulbs down rear of the cooker and feed
through the access hole in the rear oven wall. Clip bulbs into
the retaining brackets.
7. Reconnect electronic connectors.
8. Reassemble in reverse order.
To remove side panels
Pull cooker forwards to gain access to the rear of the cooker and
follow access procedure as per the heading ‘To replace gas
control valves’, up to point 2.
1. Remove 3 phillips head screws at the rear flange of the panels.
2. Remove the screw either side at front securing side panels to
fascia support plate.
3. Remove the phillips head screws down front flange of panels
4. Remove the panels.
5. Reassemble in reverse order.
To replace the function selector control
Follow access procedure as per the heading ‘Access to under
hob area’.
1. Disconnect the electronic connectors. Mark the connectors
so they are replaced in the correct position.
2. Unscrew the 2 phillips head screws which secure the function
selector control to the fascia support plate and remove the
control.
3. Replace the control and reconnect the electronic connectors.
Summary of Contents for LUEP51-90-S
Page 35: ...Part no W1885 Revision D 2006...
