La Germania LUEP51-90-S, User Instructions

9

Energy consumption

Burners

Gas type

Pressure (kPa)

Injector (mm)

Mj/hr Watts

Small

Natural

1.0

0.90

3.85

-

LPG

2.75

0.54

3.25

-

Medium

Natural

1.0

1.18

7.12

-

(x2)

LPG

2.75

0.70

5.75

-

Large

Natural

1.0

1.55

12.5

-

LPG

2.75

0.92

11.25

-

Wok

Natural

1.0

1.65

13.1

-

LPG

2.75

0.95

13.1

-

Oven/Grill

3000 W

Test the operation of the cooker before leaving

Note: These burners have no aeration adjustment.
Check correct operation of the ignition system and operation of
burners individually and in combination. Burner flames should

be clear blue, with no yellow tipping. If the burners show any
abnormality check that burner heads are correctly located. If
satisfactory performance cannot be obtained, contact Sampford

& Staff or the local gas utility. For service contact number refer
below.

Important

Before leaving instruct the owner in the use of the cooker.

Warranty warning

It should be expressly noted that we cannot accept any liability
for direct or indirect damage caused by wrong connection or
improper installation. When being repaired, the appliance must

always be disconnected from the mains supply; if required, notify
our customer service.

For service to this appliance

For service to this appliance please contact:

Sampford & Staff P/L

52 - 70 Sparks Avenue
Fairfield, Vic, 3078

Phone:

1300 727 421

Fax:

1300 727 425

Email: service@sampford.com.au

This appliance is imported
and distributed by:

28

Service and
maintenance must be
carried out by an
authorised person

Always disconnect the gas supply and power before servicing
the cooker.
After service always check connections for gas soundness  at
connections with soapy water. NEVER use a naked flame to check

for leaks.

To remove glass lid (for cookers fitted with a glass lid)

1. Place lid in the open position.
2. Lift the lid out of the hinge brackets.
3. Store in a safe place.

Access to under hob area

Pull cooker forwards to gain access to the rear of the cooker.
1. Remove glass lid, if fitted, as per heading ‘To remove glass

lid’.

2. Remove pan supports, burner caps and burner heads.
3. Using a torx T20 head driver remove the screws securing the

burners to the hob. 2 per boiling burner and 4 for the wok
burner.

4. Remove the lower 2 screws of each glass hinge/upstand

bracket.

5. Lift hob at rear and slide out of position.

To replace gas control valves or gas manifold

Pull cooker forwards to gain access to the rear of the cooker and

follow procedure above to gain access to under hob area.
1. Remove the 7 control knobs, 5 electronic clock buttons and

the thermostat indicator light cover.

2. Remove the control facia panel, by using a phillips head

screwdriver to remove 2 screws either side from inside the

underhob area.

3. Remove the 2 screws securing the burner support assembly

to the cooker rear frame.

4. The whole burner support assembly can now be pulled

towards the rear to disengage the three front locating slots
allowing access to the manifold and gas control valve
clamping screws.

5. To replace a valve unscrew the safety shut off lead and spark

ignition module. Undo the gas supply pipe and the clamping
screws and replace the valve.

6. Remove all 5 gas control valves to replace the gas manifold.
7.  Reassemble in reverse order.

Service information