Operating The Appliance
Positioning The Appliance
Connect the power cable to a permanent, 13-amp, supply located in a safe, dry area. If absolutely necessary,
only use an extension lead that meets the requirements stated in the Care and safe use guidelines.
•
Press the left switch down (icon ‘I’) to turn on the left side element for 800w heat.
•
Press the right switch down (icon ‘I’) to turn on the right side elements for 1600w heat.
•
To turn on all elements, press both switches down to give 2400w heat.
•
To turn off the heaters, press the switches up (icon ‘O’).
When choosing a mounting position, it is important to ensure the heater lights are NOT pointed towards combustible
surfaces. To adjust, loosen the wing nuts on the side, set the heater-light to desired position and re-tighten. Take care not
to pinch the cable between the back of the fittings and the plate. DO NOT ADJUST WHEN HOT!
