EN
7
7. Installation
- This appliance must be installed to
comply with applicable federal, state
or local electrical and plumbing codes.
Installation also must comply with
manufacturer’s instructions and must be
performed by qualified and authorized
personnel.
- Check to see that the data on rating plate
corresponds to those of the main electrical
supply which the machine will be hooked
up to.
- This appliance must be installed to
comply with applicable federal, state
or local electrical and plumbing codes.
Installation also must comply with
manufacturer’s instructions and must be
performed by qualified and authorized
personnel.
- Incorrect installation may cause injury/
damages to people, animals or objects, for
which the manufacturer shall not be held
responsible.
- Safe electrical operation of this appliance
will be achieved only when the connection
to power outlet has been completed
correctly and in observance of all local,
national, and international electrical codes
and safety regulations, and particularly by
grounding the unit. Make sure grounding
has been done properly as it represents
a fundamental safety requirement.
Ensure qualified personnel check such
connection.
- Furthermore, you must ensure that
the capacity of the available electrical
system is suitable for the maximum power
consumption indicated on the appliance.
- We do not recommend using adapters,
multiple plugs and/or extension cords.
If you cannot avoid using them, make
sure that they are exclusively of the kind
which conforms to local, national and
international electrical codes, and safety
regulations, being careful not to exceed
the power and current ratings indicated on
such adapters and extension cords.
- The hopper must be fastened to
appliance’s grinding system by means of
the relevant screw which must be inserted
in the threaded hole located on the upper
grinding blade holder and in the hole on
hopper neck.
- thoroughly clean the appliance at the
first installation; follow the instructions
included in this manual.
WARNING
This appliance must be placed
in a horizontal position on a
counter higher than 90cm from
the ground.
WARNING
This machine is intended to be
permanently connected to fixed
wiring, and it is mandatory that
a residual current device (RCD)
with a rated residual operating
current not exceeding 30mA is
installed.
WARNING
This machine is not suitable
for outdoor use. Jets of water
should not be used to clean the
machine, nor should it be placed
where water jets are used.