ANTHEA – VENERE
10
7194201 Rev.06 – IT
Sono
vietate
e
pertanto
pregiudicano
il
buon
funzionamento dell’apparecchio: fibrocemento, acciaio
zincato, superfici interne ruvide e porose. In Figura 4 sono
riportati alcuni esempi di soluzione.
La sezione minima deve essere di 4 dm
2
(per esempio
20x20cm) per gli apparecchi il cui diametro di condotto
è inferiore a 200mm, o 6,25dm
2
(per esempio 25x25cm)
per gli apparecchi con diametro superiore a 200mm.
Il tiraggio creato dalla vostra canna fumaria deve essere
sufficiente ma non eccessivo.
Una sezione della canna fumaria troppo importante può
presentare un volume troppo grande da riscaldare e dunque
provocare delle difficoltà di funzionamento dell’apparecchio;
per evitare ciò provvedete ad intubare la stessa per tutta la
sua altezza. Una sezione troppo piccola provoca una
diminuzione del tiraggio.
La
canna
fumaria
deve
essere
adeguatamente
distanziata da materiali infiammabili o combustibili
mediante un opportuno isolamento o un’intercapedine
d’aria.
E’ vietato far transitare all’interno della canna fumaria
tubazioni d’impianti o canali di adduzione dell’aria. E’
proibito inoltre praticare aperture mobili o fisse, sulla stessa,
per il collegamento di altri apparecchi diversi.
6. COLLEGAMENTO AL CAMINO
Gli apparecchi con chiusura automatica della porta (tipo 1) devono obbligatoriamente funzionare, per motivi di
sicurezza, con la porta del focolare chiusa (fatta eccezione per la fase di carico del combustibile o l’eventuale
rimozione della cenere).
Gli apparecchi con le porte non a chiusura automatica (tipo 2) devono essere collegati ad una propria canna
fumaria. Il funzionamento con porta aperta è consentito soltanto previa sorveglianza.
Il tubo di collegamento alla canna fumaria deve essere più corto possibile, rettilineo, a tenuta stagna e
conforme alle normative vigenti.
Il collegamento deve essere eseguito con tubi stabili e robusti (Vi consigliamo uno spessore di 2 mm) ed
essere fissato ermeticamente alla canna fumaria
. Il diametro interno del tubo di collegamento deve
corrispondere al diametro esterno del tronchetto di scarico fumi della
stufa
( DIN 1298 ).
ATTENZIONE: qualora il collegamento attraversi particolari composti da materiali infiammabili, nel raggio di
20cm attorno al tubo tutti i materiali infiammabili devono essere sostituiti da materiali ignifughi e resistenti al
calore .
Per un buon funzionamento dell’apparecchio è essenziale che nel luogo d’installazione venga immessa
sufficiente aria per la combustione (vedi paragrafo 10).
La depressione al camino
dovrebbe essere 12-14 Pa (=1,2-1,4 mm di colonna d’acqua).
La misurazione deve essere fatta sempre ad apparecchio caldo (resa calorifica nominale). Quando la
depressione supera 17 PA (1,7 mm di colonna d’acqua) è necessario ridurre la stessa con l’installazione di un
regolatore di tiraggio supplementare (valvola a farfalla) sul tubo di scarico o nel camino.
Per motivi di sicurezza la porta del focolare può essere aperta solo durante il caricamento di combustibile. Il
focolare deve rimanere chiuso durante il funzionamento ed i periodi di non-utilizzo.
6.1.
POSIZIONE DEL COMIGNOLO
Il tiraggio della canna fumaria dipende anche dall’idoneità del comignolo.
È pertanto indispensabile che, se costruito artigianalmente, la sezione di uscita sia più di due volte la sezione
interna della canna fumaria.
Dovendo sempre superare il colmo del tetto, il comignolo dovrà assicurare lo scarico anche in presenza di
vento (Figura 5).
Figura 4
(1) Canna fumaria in acciaio AISI 316 con doppia
camera isolata con materiale resistente a
400°C. Efficienza 100% ottima.
(2) Canna fumaria in refrattario con doppia
camera isolata e rivestimento esterno in
calcestruzzo alleggerito. Efficienza 100%
ottima.
(3) Canna fumaria tradizionale in argilla sezione
quadrata con intercapedini. Efficienza 80%
ottima.
(4)
Evitare
canne
fumarie
con
sezione
rettangolare interna il cui rapporto sia diverso
dal disegno.
Efficienza 40% mediocre.
A+1/2A
A
Max.
A+1/2A
(3)
(1)
(2)
(4)
Summary of Contents for ANTHEA
