FOCOLARI in ghisa
12
6097000 – IT
Gli spazi previsti per la circolazione dell’aria indicati nelle figure sotto riportate (Fig. 14 - Fig. 15) sono i requisiti
minimi:
Sommità: apertura minima 1000 cm
2
Base: apertura minima 750 cm
2
Si otterrà quindi:
•
una maggiore sicurezza
•
un aumento del calore creato dalla circolazione d’aria attorno all’apparecchio.
La griglia di sfiato calore (Fig. 16 pos. 6 ) va installata sulla parte superiore della cappa a circa 20 cm dal soffitto.
Questa deve sempre essere installata in quanto la sua funzione è quella di lasciare fuoriuscire nel locale il calore
accumulato all’interno della cappa (sovrappressione).
7.1.
PRESA D’ARIA ESTERNA
Per un buon funzionamento dell’apparecchio è essenziale che nel luogo d’installazione venga immessa sufficiente
aria per la combustione e la riossigenazione dell’ambiente stesso. Ciò significa che, attraverso apposite aperture
comunicanti con l’esterno, deve poter circolare aria per la combustione anche a porte e finestre chiuse.
•
La presa d’aria deve essere posizionata in modo da non poter essere ostruita
•
Essere comunicante con il locale d’installazione dell’apparecchio ed essere protetta con una griglia.
•
La superficie minima non deve essere inferiore a 200cm2.
•
Qualora l’afflusso d’aria fosse ottenuto attraverso aperture comunicanti con l’esterno di locali
adiacenti sono da evitare prese d’aria in collegamento con garage, cucine, bagni, centrali termiche.
8.
COLLEGAMENTO E MANUTENZIONE VENTILAZIONE
La centralina e l’impianto dovranno essere installate e collegate da personale abilitato secondo le norme
vigenti.(Vedi Cap.1)
ATTENZIONE il cavo di alimentazione NON deve essere a contatto con parti calde.
I nostri focolari possono essere dotati di opportune carenature zincate (OPTIONAL) sulle quali possono essere
installati kit di ventilatori (OPTIONAL) adatti a migliorare la distribuzione del calore attraverso la ventilazione del solo
ambiente di installazione oppure del locale adiacente (v. CAP. 6).
L’accensione e la regolazione viene effettuata tramite l’apposita centralina in dotazione la quale dovrà essere
installata lontana da fonti di calore dirette. Il kit é dotato di un termostato (TM) che fa avviare i ventilatori quando
l’apparecchio è adeguatamente riscaldato e li arresta quando è parzialmente freddo.
Fig. 16
(6) Griglia sfiato calore
(7) Controcappa ignifuga
(9) Schermare le parti in legno
con materiale isolante
(8) Inclinazione massima 45°
(2) Sigillare
(3) Rivestimento isolante provvisto
di foglio di alluminio esterno
(4) Sportello per pulizia
(5) Presa aria esterna
(1) Isolante
(10) Distanza posteriore e laterali
minimo 10 cm