LA VENEZIA-17 ESPRESSO MACHINE USER MANUAL
4
12.
Do not install in rooms cleaned using water jets. At any rate, avoid cleaning the machine
with water jets.
13.
Do not plug or clog the ventilation and heat-exhausting louvres.
14.
If the machine’s electrical cord is damaged, it should be replaced. This should only be
done by an authorized service technician.
15.
If the machine is stored on premises where the temperature may drop below freezing
point, always empty the boiler and the water circulation pipes.
16.
Boxes may be stacked in piles of up to three units of the same model. Do not place other
heavier packages on top of the box.
CONNECTING THE MACHINE
Place the machine on a perfectly levelled surface, adjusting and then fixing the feet in place.
Select a level, dry, strong and stable installation surface at least 110 cm off the floor.
The place where the machine is to be installed must have a connection to the water supply
network, to the sanitation network and a connection to the electricity network with the same
characteristics as those indicated on the data plate of the machine.
Make the hydraulic connections in conformity to the hydraulics safety laws in force in the
country of installation.
If the main pressure could rise above 6 bar, install a pressure reducer calibrated at 2-3 bar
before the softener.
The Installation of the machine to the water mains connection must be done by a qualified
person.
Rinse around 10 liters of water from the main water supply before connecting the machine to
the water connection to clean deposited particles.
Connect the inlet hose that is assembled in the machine (accessible under the working tray)
to the main water supply, which should have a 3/8” male connection fitted with a shut-off
valve, tighten it with a wrench.
