35
We recommend that you make a note of its serial number in this booklet prior to installation, so that you
can refer to it later (technical work, request for assistance, etc.).
Once the appliance is installed and loaded, access to it is not so easy.
CAUTION: no assistance can be provided without this information.
4. INSTALLATION INSTRUCTIONS
Before using this appliance
•
Remove the exterior and interior packing.
•
Before connecting the appliance to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
When disposing your appliance, please choose an authorized disposal site.
•
Place your wine cooler on a floor that is strong enough to support it when it is fully loaded. To level
your Wine cooler, adjust the front leveling leg at the bottom of the wine cooler.
•
Adequate ventilation is required, do not block the front air outlet.
•
This wine cellar is designed for
free-standing only
,
in no case it must be installed in a built-in or
embeddable way.
For a good functionality of the device it is imperative to leave a good air circulation
all around the device. We do not take responsibility for failure to comply with the installation
instructions.
•
Not designed for placement in adage or basement.
•
The appliance is for indoor use only.
•
This appliance is intended to be used exclusively for the storage of wine.
•
This appliance is using flammability refrigerant. So never damage the cooling pipe work during the
transportation.
•
Connect the appliance to a single socket, leaving a 10 cm gap between the back of the cellar and
the wall. Be careful to support it, so that your wine cooler is perfectly level (the use of a spirit level is
recommended). This will prevent any movement due to instability, generating noise and vibration,
and will ensure that the door seals perfectly.
Attention
•
Store wine in sealed bottles.
•
Do not overload the cabinet.
•
Do not open the door unless necessary.
•
Do not cover shelves with aluminum foil or any other shelf material which may prevent air circulation.
•
Should the wine cooler be left empty for long periods it is suggested that the appliance is unplugged,
and after careful cleaning, leave the door ajar to allow air to circulate inside the cabinet in order to
avoid possible condensation, mold or odors forming.
