26
IMPORTANT: if the power cable supplied is damaged, it must be replaced by the manufacturer, a
service centre approved by the brand or the retailer. In all events, it must be replaced by qualified
personnel in order to avoid any risk of injury.
I
F THESE CHECKS REVEAL NOTHING
,
THEN CONTACT YOUR RETAILER
’
S
A
FTER
-S
ALES
D
EPARTMENT
CAUTION!
Unplug the appliance before carrying out any maintenance or repair work.
10. TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
Wine cooler does not operate
Not plugged in
The appliance is turned off
The circuit breaker tripped or a blown fuse
Wine cooler is not cold enough
Check the temperature control setting
External environment may require a higher setting
The door is opened too often
The door is not closed completely
The door gasket does not seal properly
Turns on and off frequently
The room temperature is hotter than normal
A large amount of contents has been added to the wine cooler.
The door is open too often
The door is not closed completely
The temperature control is not set correctly
The door gasket does not seal properly
The light does not work
Not plugged in
The circuit breaker tripped or a blown fuse
The bulb has burned out
The light switch is “OFF”
Vibrations
Check to assure that the wine cooler is level
The wine cooler seems to make
too much noise
The rattling noise may come from the flow of the refrigerant, which is
normal
As each cycle ends, you may hear gurgling sounds caused by the
flow of refrigerant in your wine cooler
Contraction and expansion of the inside walls may cause popping
and crackling noises
The wine cooler is not level
The door will not close properly
The wine cooler is not level
The door was reversed and not properly installed
The gasket is dirty
The shelves are out of position
The code “HH” is displayed on
the control board
If the temperature is too high (>30°C), the code "HH" appears on the
display and an audible alarm sounds.
The audible alarm can be deactivated immediately by pressing the
“on” / “off” button or by unplugging the cellar. In this case please
contact the after-sales service.
The co
de “LL” is displayed on
the control board
If the temperature is too low (<3°C), the code "LL" appears on the
display and an audible alarm sounds.
The audible alarm can be deactivated immediately by pressing the
“on” / “off” button or by unplugging the cellar. In this case please
contact the after-sales service.
