30
10. TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
Wine cooler does not operate
Not plugged in
The appliance is turned off
The circuit breaker tripped or a blown fuse
Wine cooler is not cold enough
Check the temperature control setting
External environment may require a higher setting
The door is opened too often
The door is not closed completely
The door gasket does not seal properly
Turns on and off frequently
The room temperature is hotter than normal
A large amount of contents has been added to the wine cooler.
The door is open too often
The door is not closed completely
The temperature control is not set correctly
The door gasket does not seal properly
The light does not work
Not plugged in
The circuit breaker tripped or a blown fuse
The bulb has burned out
The light switch is “OFF”
Vibrations
Check to assure that the wine cooler is level
The wine cooler seems to make
too much noise
The rattling noise may come from the flow of the refrigerant, which is
normal
As each cycle ends, you may hear gurgling sounds caused by the
flow of refrigerant in your wine cooler
Contraction and expansion of the inside walls may cause popping
and crackling noises
The wine cooler is not level
The door will not close properly
The wine cooler is not level
The door was reversed and not properly installed
The gasket is dirty
The shelves are out of position
The code “HH” is displayed on
the control board
If the temperature is too high (>30°C), the code "HH" appears on the
display and an audible alarm sound.
The audible alarm can be deactivated immediately by pressing the
“on” / “off” button or by unplugging the cellar. In this case please
contact the after-sales service.
The
code “LL” is displayed on
the control board
If the temperature is too low (<3°C), the code "LL" appears on the
display and an audible alarm sound.
The audible alarm can be deactivated immediately by pressing the
“on” / “off” button or by unplugging the cellar. In this case please
contact the after-sales service.
Replacing light
This appliance consists of light-emitting diodes (LEDs). This type of diode
cannot be changed by the consumer. The lifetime of these LEDs is normally
sufficient for no change to be made. If however, and despite all the care
taken during the manufacture of your wine cellar, the LEDs were defective,
please contact your after-sales service for any intervention.
