47
10. TROUBLE SHOOTING
You can solve many common Wine cooler problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
POSSIBLE CAUSE
Wine cooler does not operate
•
Not plugged in
•
The appliance is turned off
•
The circuit breaker tripped or a blown fuse
Wine cooler is not cold enough
•
Check the temperature control setting
•
External environment may require a higher
setting
•
The door is opened too often
•
The door is not closed completely
•
The door gasket does not seal properly
Turns on and off frequently
•
The room temperature is hotter than normal
•
A large amount of contents has been added to
the wine cooler.
•
The door is open too often
•
The door is not closed completely
•
The temperature control is not set correctly
•
The door gasket does not seal properly
The light does not work
•
Not plugged in
•
The circuit breaker tripped or a blown fuse
•
The bulb has burned out
•
The light switch is “OFF”
Vibrations
•
Check to assure that the wine cooler is level
The wine cooler seems to make too much noise
•
The rattling noise may come from the flow of
the refrigerant, which is normal
•
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
wine cooler
•
Contraction and expansion of the inside walls
may cause popping and crackling noises
•
The wine cooler is not level
The door will not close properly
•
The wine cooler is not level
•
The door was reversed and not properly
installed
•
The gasket is dirty
•
The shelves are out of position
In case of display of an error code (ie P1, LA, HA...), unplug your appliance from the
main power, and contact your after sales service.
Replacing light
This appliance consists of light-emitting diodes (LEDs). This type of diode
cannot be changed by the consumer. The lifetime of these LEDs is normally
sufficient for no change to be made. If however, and despite all the care taken
during the manufacture of your wine cellar, the LEDs were defective, please
contact your after-sales service for any intervention.