The FT Series Floor Standing, Combination Boiler
Page 55
5.2
LCD Overview
CH mode
Central Heat mode icon can be adjusted
Anti-freeze mode
Anti-freeze mode icon
Storage Heating mode
Stored Water Being Heated, can be adjusted
Lock mode
Buttons-locked mode icon
Communication
Communication icon
Summer mode
Only DHW Mode, can be adjusted (warm weather shutdown)
Status and Installer mode
The Status Mode or the Installer Mode is Active (all parameters)
Flame signal
Flame Signal icon
Pump icon
Water pump operation (CH or DHW) icon
Numeric Display
Number and character display, to display all parameters
DHW mode
Combination boiler Set Point, can be adjusted
Outside temp or 0-10 V mode
Operating by outside temperature or 0-10V
Numeric Display
Domestic Hot Water Mode
Anti-Freeze
Mode
Storage
Heating
Lock
Communicating
Status and
Installer
Modes
Flame
Signal
Pump
Outside
Temp Mode
or 0-10V
Summer Mode
(warm
weather
shutdown)
CH
Central
Heat
WARNING
Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of
the control system and any gas control that may have
been under water.
The LCD will illuminate when a user action is detected (a button is pressed) and will turn
back off after 20 seconds.
* NOTE: The display will not allow changes when the lock mode
is activated.
To exit the Lock mode, press the
button.
