Page 13
N
EO
T
HERM
Boilers and Water Heaters
Lead/Lag Slave configuration continues
13
Slide Bar
3. Change
both
MB1 and MB2
address.
Press on
EACH
address box to change the address.
4. Use the arrows on the screen to change the address
number, then press
“OK”. Repeat this on each slave boiler
keeping them in sequential order.
5. Next, press the back arrow on the top right corner of the screen.
This will return you to the “Configure Menu”.
6. You will need to confirm the master configuration function
on each
Slave
boiler is disabled.
On the slave controls scroll down and press on
“Lead Lag Master Configuration”
.
7. Press the “Enable” box and change it to
“Disabled
”, then press
“OK”.
8. Next, press the back arrow on the top right corner of the screen.
This will return you to the “Configure Menu”.
