NeoTherm Boilers and Water Heaters
Page 59
1. From the Home screen (Fig. 61), press the icon
for the controller you want to work with. In
this example, we will start with the Secondary
controller for Boiler 1, and make sure this is
not set up as a Master.
fig. 61 – Home Screen
2. The system will take you to the Status
Summary screen.
fig. 62 – Status Summary Screen
3. To disable the Master function on this
controller, press the Configure button. Figure
63 shows the Configuration screen.
Fig. 63 – Configuration Screen
4. Scroll down through the list until you find the
line for LL Master Configuration. See Fig. 64.
Fig. 64 – Lead/Lag Master Configuration
Press on the line for Master Enable. The
system will go to a separate screen and ask
you to login using a password. Enter the
password (see Section 8.2), return to the Master
Configuration screen, then press the line for
Master Enable again. Change the entry to
Disabled.
Don’t change any of the other entries on this
screen.
Summary of Contents for NTV1000
