ULTRASONIC CLEANER
B.
Starting Method
i.
If you have basket, put in the sump.
ii.
Put cleaning stuff into sump.
iii.
Put liquid into sump until going to indication line.
iv.
POWER ON. LED and FND test and then wait to be ready to operate.
v.
Press SET KEY once and set temperature of liquid. (TEMP SET MODE).
1.
If press SET KEY first time, FND-TEMP is blink. UP/DOWN Key to
set the desired temperature can be used.
2.
Heater lamp is automatically ON/OFF, compared with the current
temperature and the set temperature.
vi.
In TEMP SET MODE, press SET KEY once more and then FND-TIME is
blink. In same way, set cleaning time by pressing UP/DOWN KEY.
(TIME SET MODE).
vii.
In TIME SET MODE, press SET KEY once more and the selected MODE
LED is blink, changing into Operation Selection Mode. UP/DOWN Key
to select the proper mode can be used. (OPERATION SELECTION
MODE).
viii.
In OPERATION SELECTION MODE, press SET KEY once more again and
then goes into POWER SELECTION Mode. The selected POWER LED is
blink. UP/DOWN Key to select the power can be used. (OUTPUT
POWER SELELCTION MODE)
ix.
In OUTPUT POWER SELECTTION MODE, if press SET KEY. Every setting
is finished and changed into NORMAL Operation MODE. All of the
selected are stored. Even though POWER is OFF, it is maintained.
x.
Press SONIC ON/OFF, SONIC LED lights up and begins to ultrasonic
cleaning.
xi.
Cleaning time is displayed in minutes in subtraction mode while
ultrasonic cleaning. Namely, remaining time is displayed by MIN.
xii.
If you want to stop cleaning before settled time, press SONIC KEY.
xiii.
The ultrasonic cleaning time is set to 00, four hours of continuous use
is possible.
DOMINIQUE
DUTSCHER SAS
