FP+ Series Operation Manual
35
TEChNICAL sPECIFICATIONs 9
Following are the FP+ Series technical specifications. These figures are accurate at the time of printing but
please note that all figures are subject to change without notice. For the most accurate and current information
available, please visit www.labgruppen.com.
Model
Number of channels
Peak total output all channels driven
Peak output voltage per channel
Max. output current per channel
Max. Output Power
16 ohms per ch. (all ch.’s driven)
8 ohms per ch. (all ch.’s driven)
4 ohms per ch. (all ch.’s driven)
2 ohms per ch. (all ch.’s driven)
16 ohms Bridged per ch.
8 ohms Bridged per ch.
4 ohms Bridged per ch.
2 ohms Bridged per ch.
Performance with Gain
THD 20 Hz - 20 kHz for 1 W
THD at 1 kHz and 1 dB below clipping
Signal To Noise Ratio
Channel separation (Crosstalk) at 1 kHz
Frequency response (1 W into 8 ohms) +0/-3 dB
Input Impedance
Input Common Mode Rejection, CMR
Output impedance @ 100 Hz
Voltage Peak Limiter (VPL), max. peak output
VPL, selectable per ch. (V)
VPL, selectable when bridged (V)
1)
Voltage Peak Limiter mode (per ch.)
Hard / Soft
Gain and Level
Amplifi er gain selectable (all channels)
1)
– rear-panel switches
23, 26, 29, 32, 35, 38, 41, 44 dB
Default gain
38 dB
35 dB
38 dB
35 dB
35 dB
35 dB
35 dB
Level adjustment (per ch.)
Front-panel potentiometer, 31 position detented from -inf to 0 dB
Connectors and switches
Input connectors (per ch.)
3-pin XLR, electronically balanced
Output connectors (per ch.)
Neutrik Speakon or Binding Posts (must be specified upon order). BP only on FP 14000, FP 13000, FP 9000.
Output bridge mode per two ch.’s
A+B - Ch. A is signal input source. A+B, C+D - Ch.’s A and C are input source
NomadLink network
2 x RJ45 EtherCon connectors, IN and OUT
Intelligent fans (on/off)
Yes, depending on presence of output signal
Power on/off and Remote enable on/off
Individual switches on front-panel
Cooling
Two fans, front-to-rear airfl ow, temperature controlled speed
front-panel indicators
Common
NomadLink
network; Power Average Limiter (PAL)
2)
; Power on
Per channel
Signal present / High-impedance; -20 dB, -15 dB, -10 dB and -4 dB output
signal; Voltage Peak Limiter (VPL); Current Peak Limiter (CPL):
Very High Frequency (VHF); High temperature; Fault; Mute
Power
Operating voltage, 230 V / 115 V nominal
4)
130-265 V / 65-135 V
Minimum power-up voltage, 230 V / 115 V
171 V / 85 V
Power Average Limiter (PAL)
2)
Yes
Soft start / Inrush Current Draw
Yes / max. 5 A
Mains connector
230 V CE: 16 A, CEE7; 115 V ETL: 30 A Twist lock
|
FP 4000:
230 V CE: 16 A, CEE7; 115 V ETL: 20 A / NEMA 5-20P
dimensions (W/h/d)
W: 483 mm (19”), H: 88 mm (2 U), Overall D: 396 mm (15.6”), Mounting D: 358 mm (14.1”)
Weight
12 kg (26.4 lbs.)
finish
Black painted steel chassis with black painted steel / aluminum front
Approvals
CE, ANSI/UL 60065 (ETL), CSA C22.2 NO. 60065, FCC
Note 1):
Automatic -6 dB gain compensation when bridging channels.
Note 2):
PAL can reduce the maximum output power to keep the power supply operating safely, and/or to prevent excessive current draw tripping the mains breaker.
Refer to section 7.5.8 Power Average Limiter (PAL) for more information.
Note 3):
The amplifier will be fully operational at bridge-mode 2 ohm loads, but due to physical constraints in the construction, the max. output power will not be
significantly higher than running individual channels and therefore not stated here.
Note 4):
Separate 230 V or 115 V versions available. Not selectable on the amplifier.
All specifications are subject to change without notice.
fP 14000
fP 13000
fP 9000
fP 7000
fP 4000
fP 10000q
fP 6000q
2
2
2
2
2
4
4
14000 W
13000 W
9000 W
7000 W
4000 W
10000 W
6000 W
195 V
195 V
170 V
155 V
121 V
150 V
101 V
85 A peak
82 A peak
70 A peak
59 A peak
50 A peak
54 A peak
38 A peak
1200 W
1200 W
800 W
730 W
400 W
660 W
320 W
2350 W
2350 W
1600 W
1450 W
800 W
1300 W
625 W
4400 W
4400 W
3000 W
2800 W
1600 W
2100 W
1250 W
7000 W
6500 W
4500 W
3500 W
2000 W
2500 W
1500 W
4700 W
4700 W
3200 W
2900 W
1600 W
2600 W
1250 W
8800 W
8800 W
6000 W
5600 W
3200 W
4200 W
2500 W
14000 W
13000 W
9000 W
7000 W
4000 W
5000 W
3000 W
3)
3)
3)
3)
3)
3)
3)
35 dB and VPL:
195 V
35 dB and VPL:
195 V
35 dB and VPL:
170 V
35 dB and VPL:
155 V
35 dB and VPL:
121 V
35 dB and VPL:
150 V
35 dB and VPL:
101 V
<0.1%
<0.1%
<0.1%
<0.1%
<0.1%
<0.1%
<0.1%
<0.05%
<0.05%
<0.05%
<0.05%
<0.05%
<0.05%
<0.05%
>112 dBA
>112 dBA
>112 dBA
>112 dBA
>112 dBA
>112 dBA
>112 dBA
>70 dB
>70 dB
>70 dB
>70 dB
>70 dB
>70 dB
>70 dB
2 Hz - 34.2 kHz
6.8 Hz - 34 kHz
2 Hz - 34.2 kHz
6.8 Hz - 34 kHz
2 Hz - 34.2 kHz
6.8 Hz - 34 kHz
6.8 Hz - 34 kHz
20 kOhm
20 kOhm
20 kOhm
20 kOhm
20 kOhm
20 kOhm
20 kOhm
54 dB
54 dB
54 dB
54 dB
54 dB
54 dB
54 dB
19 mOhm
19 mOhm
19 mOhm
19 mOhm
32 mOhm
32 mOhm
32 mOhm
195, 170, 140,
116, 100, 80, 66,
54 V
195, 170, 140,
116, 100, 80, 66,
54 V
170, 140, 116,
100, 80, 66,
54 V
155, 121, 101,
83, 70, 56, 47,
38 V
121, 101, 83, 70,
56, 47, 38 V
150, 121, 101,
83, 70, 56, 47,
38 V
101, 83, 70, 56,
47, 38 V
390, 340, 280,
232, 200, 160,
132, 108 V
390, 340, 280,
232, 200, 160,
132, 108 V
340, 280, 232,
200, 160, 132,
108 V
310, 242, 202,
166, 140, 112,
94, 76 V
242, 202, 166,
140, 112, 94,
76 V
300, 242, 202,
166, 140, 112,
94, 76 V
202, 166, 140,
112, 94, 76 V
