4
FP+ Series Operation Manual
This equipment conforms to the requirements of the EMC Directive 2004/108/EC and the requirements of the Low Voltage Directive 2006/95/EC.
Standards applied: EMC Emission EN55103-1, E3
EMC Immunity EN55103-2, E3, with S/N below 1% at normal operation level.
Electrical Safety EN60065, Class I
This equipment is tested and approved according to the U.S. safety standard ANSI/ UL 60065 and Canadian safety standard CSA C22.2 NO. 60065. ETL
made the tests and they are a Nationally Recognized Testing Laboratory (NRTL).
3.1 Explanation of graphical symbols
The lightning symbol within a triangle is intended to alert the user to the presence of un-insulated “dangerous voltages” within the unit’s chassis that may be of
sufficient magnitude to constitute a risk of electric shock to humans.
The exclamation point within a triangle is intended to alert the user to presence of important operating and service instructions in the literature accompanying the
product.
3.1.1
WARNING
3.1.2 CAuTION
3.2 Important Safety Instructions
Before using your FP+ Series product, be sure to carefully read the applicable items of this Operation Manual and the Safety Instructions.
1.
Keep this manual for future reference.
Heed all warnings.
2.
Follow all instructions.
3.
Do not use this unit near water.
4.
Do not spill water or other liquids into or on the unit. Do not operate the unit while wet or standing in liquid.
5.
Clean only with dry cloth.
6.
Do not block the air intake or exhaust ports. Install the unit in accordance with the instructions.
7.
Do not operate the unit near heat producing devices such as radiators, heat registers, stoves or other apparatus that produce heat. Always operate the unit with the chassis ground wire connected to the
8.
electrical safety earth. Do not defeat the safety purpose of a grounding-type plug. A grounding-type plug has two pins and a third grounding prong. The third prong is provided for your safety. If the provided
plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
Connect only to AC power outlets rated 100-120 V or 200-240 V, 50-60 Hz as dictated by the unit’s voltage configuration.
9.
Do not use this unit if the power cord is broken or frayed. Protect the power cord from being walked upon or pinched, particularly at the plug and the point where it exits from the apparatus.
10.
Only use accessories specified by the manufacturer.
11.
The unit is intended to use in a 19” rack. Follow the mounting instructions. When a rack on wheels is used, use caution when moving the loaded rack to avoid injury from tipping over.
12.
Unplug this apparatus during lightning storms or when unused for long periods of time.
13.
Do not connect the unit’s outputs in parallel or series with any other unit’s output. Do not connect the unit’s output to any other voltage source, such as battery, mains source, or power supply, regardless
14.
of whether the unit is turned on or off.
Do not run any of the unit’s outputs back into another channel’s input.
15.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way such as:
16.
Power-supply cord or plug is damaged.
▸
Liquid has been spilled into the unit
▸
An object has fallen into the unit
▸
The unit has been exposed to rain or moisture
▸
The unit does not operate normally
▸
The unit was dropped or the chassis is damaged
▸
17.
Do not remove top or bottom covers. Removal of the covers will expose hazardous voltages. There are no user serviceable parts inside and removal may void the warranty.
18.
An experienced user shall always supervise this professional audio equipment, especially if inexperienced adults or minors are using the equipment.
19.
The mains plug is used as the disconnect device and shall remain readily accessible. If the mains plug is not readily accessible due to mounting in a 19” rack, then the mains plug for the entire rack must be
readily accessible.
20.
The US National Differencescl.16.3 requires that network cables must be flame rated VW-1.
2 APPROVALs
3 WARNINGs
To reduce risk of fire or electric shock, do not expose this apparatus to rain or moisture.
Do not expose this system/apparatus to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the apparatus.
L’appareil ne doit pas être exposé à des egouttements d’eau ou des éclaboussures et de plus qu’aucun objet rempli de liquide tel que des vases ne doit pas être
placé sur l’appareil.
This apparatus must be connected to a mains socket outlet with a protective
earthing connection.
Cet appareil doi t être raccordé á une prise de courant qui est branchée à la terre.
The mains plug is used as a disconnect device and shall remain readily operable.
Lorsque la prise du réseau d’alimentation est utilisés comme dispositif de déconnexion, ce dispositif doit demeuré aisément accessible.
To reduce the risk of fire or electric shock, do not remove screws. No user-serviceable parts inside. Refer servicing to qualified service personnel
