6. Unpacking and visual checks
LUCIA Operation Manual rev 1.2.0
7
6. Unpacking and visual checks
condition. If any damage is discovered, please notify the shipping carrier immediately. Save the packing materials
for the carrier’s inspection and for any future shipping.
7. Installation
7.1. Wall mounting
For attaching brackets (marked “B” on the drilling guide; see inside the shipping box) to the wall, please use
are secured properly to the wall. For drywall mounting, use a woodscrew (3.5 mm diameter with 25 mm minimum
reater than 3 kg (e.g. Molly E22412). This
method of mounting is evaluated for North America according to UL/CA60065.
For mounting on surfaces other than drywall, please ensure that the method of mounting is suitable for the wall
material. Also, be certain that the brackets are secured to the wall with the appropriate means to ensure similar
3 mm Torx machine screws.
7.2. Rack shelf mounting
of the three holes in the bottom marked “A” on
the drilling guide (see inside the shipping box). Use a 4 mm diameter machine screw (not supplied), ensuring that
the length of the screw is suitable for the thickness of the shelf. The screws used should not penetrate into the
7.3. Lab.gruppen rack shelf kit
A special dedicated rack mount shelf designed to hold two LUCIA
accessory. It includes all necessary accessories, screws, and mounting instructions.
5.4. Additional features on LUCIA 60/2, 120/2 and 240/2 only
•
Maximum output power across range of loads
– Power output remains constant into 2, 4 or 8 ohms
• Auto Load Sense™ – Proprietary auto-set VPL™ (Voltage Peak Limiter) for optimum performance
with any connected load
•
2 x 2 mix matrix
– Route input signals internally to either one or both amplifier channels
5.5. Additional features on LUCIA 60/1-70, 120/1-70 and 240/1-70 only
•
Model for constant voltage applications
– into 70 V/100 V
•
2 x 1 mix matrix
– Mix two sources to mono or use for source selection
