9
When you use your Labcold SD card for the first time it is essential that you set the
current date and time. To do this you need to insert your SD card, snowflake side up in
the slot underneath the temperature display as shown below.
The SD card will only go into the slot up
to the top of the snowfl ake and should not
be inserted any further
Once the card is inserted, wait 5 seconds then press the tick/confi rm button located to the left
of the card slot. The fridge will beep and then the word
date
will show on the display.
The display will then change to allow you to set the year.
10
Using the up and down buttons to the right of the screen, (the top button to increase the
number, the bottom to decrease), set the numbers to the last two digits of the current year ie
for 2017 select 17.
When you have set the correct year, simply press the tick button and the display will then
change to allow you to set the month
.
To set the month, use the up and down buttons on the right, with 1 being January, 2 being
February etc.
Press the tick button when you have the correct month. The display will then change to allow
you to select the day.
To set the day, use the up and down buttons on the right until the display shows todays date.
Press the tick button when you have the correct day. The display will then change to allow you
to set the time.
Firstly, you need to set the hour by using the buttons on the right of the display.
Press the tick button when you have the correct hour. The display will then change to allow
you to set the minutes.
Set the minutes by using the up and down buttons on the right. When you have the correct
digits, press the tick button.
The fridge display will now revert to showing the temperature and the internal timer inside
your controller is now set. The card can be removed. Once the timer is set, DO NOT reset it or
adjust it, even for changes to GMT or BST, otherwise you will lose data.
IF YOUR REFRIGERATOR DOES NOT HAVE BATTERIES INSTALLED AS A BACK UP, IN THE
EVENT OF A MAINS POWER FAILURE THE TIMER MAY NEED TO BE RE-SET. FOLLOW THE
INSTRUCTIONS ABOVE TO SET THE TIMER AND PLEASE BE AWARE THAT TEMPERATURE
DATA MAY BE LOST AS A RESULT.
Although the
Labcold I
ntelli
C
old® controller can store up to 13 months worth of temperature
data, it is strongly recommended that temperature data is downloaded every week and stored
to your computer or printed as a hard copy.
The refrigerator records the conditions inside the chamber every minute and all this
information is downloadable to your
Labcold
SD card.
IN THE UNLIKELY EVENT THAT YOU HAVE A PROBLEM WITH YOUR LABCOLD
REFRIGERATOR, THE SERVICE TEAM MAY ASK YOU TO DOWNLOAD TEMPERATURE DATA
TO HELP RESOLVE THE ISSUE.
Setting the Timer
