Page 4 of 4
Step 5. Electrical Connections
Vacuum Pump
– The vacuum pump is powered through the CentriVap’s controls. If
not equipped, attach a reverse IEC connector to the power cord of the vacuum pump
so it can plug into the back of the concentrator.
CentriVap Concentrator
– Plug the CentriVap into the electrical outlet that matches the
rating shown on the label (lower-rear).
Testing or Start Up
Step 6. Testing the System
Turn the CentriVap power switch ON.
Close the lid on the CentriVap
Close the lid on the Cold Trap (if equipped)
Press the Run/Stop button
Once the CentriVap attains speed the vacuum pump should start automatically
To stop the CentriVap and vent, press the Run/Stop button
If the CentriVap or Cold Trap fails to perform as expected, c
onsult the User’s Manuals
for troubleshooting information or call Labconco.
LABCONCO CORPORATION
8811 Prospect Ave, Kansas City, MO 64132
(816) 333-8811 or (800) 821-
5525 • (816) 363-0130 fax • labconco.com
Vacuum
Hose to Trap
Vacuum Pump
Power Cord
with Reverse
IEC Connector
Power Cord
to Electrical
Service
