Chapter 4: Using Your Washer
Product Service 1-800-522-7658
30
WATER HIGH
This displays if the washer overfills with water. Water fill valves will be
closed and the washer will cancel the cycle and drain water that is in the
washer. The alarm is canceled by opening the door. See
Chapter 7:
Troubleshooting
– Washer overfills.
OVERFLOW
This displays if water is detected in the base of the washer. Water fill
valves will be closed and the washer will cancel the cycle and drain water
that is in the washer. The alarm is canceled by opening the door. See
Chapter 7: Troubleshooting
– Washer leaks.
LIQ DETER
This displays if the level of the detergent in the dispense container is low.
The alarm is disabled if the detergent dispense volume is set to “0.” The
alarm is canceled when detergent is added to the container.
RINSE AID
This displays if the level of the rinse aid solution in the dispenser
container is low. The alarm is disabled if the rinse aid dispense volume is
set to “0.” The alarm is canceled when rinse aid is added to the container.
DRAIN FAIL
This displays if water fails to completely drain during a normal drain
operation. Operation of the washer is canceled. The alarm is canceled by
opening the door.
LOW TEMP
This displays if the water does not reach the set point temperature within
135 minutes. Operation of the washer continues. The alarm cancels when
the door is opened.
RS-232 Computer Connection
The operation of the Glassware Washer can be monitored using a computer or a
stand alone printer. The computer cannot control the operation of the washer.
The monitored parameters are the water conductivity, water temperature, cycle
segment, elapsed time of each segment, and alarms. The fault alarms that are
monitored include low water fill, high water fill, low detergent and rinse aid
levels, low water temperature during Wash 2 and Wash 3 and the Final Rinse, and
if water is detected in the base. The RS-232 data is constantly sent by the washer
even when the front panel LCD is displaying other information.
Connection for computer interface:
The Glassware Washer has a 6 wire telephone cable connector on the back of the
washer near the bottom on the left side. Check your computer to see which type
of serial port is provided, then use a connecting cable below:
1.
Computers with a 25 pin D-sub male serial connector should use Connect
Cable (Labconco P/N 7537801) to connect from the user’s computer to the
Glassware Washer.
