9
4.2.2) PASSWORD
To prevent the door work program from being modified, a password can be entered that must be input every time the N-DSEL programmer is
used.
To enable the password perform the operations listed below:
1.
Press the SET button for 5 seconds to access the general programming menu (see Diagram 1 at para. 4.3.1)
2.
Press the F1 button five times to switch to the Password Management sub-menu.
3.
Press the Enter button to access the “Password management” section.
PASSWORD MANAGEMENT
This section displays the two passwords available to the final user, the primary password and the service password.
The technical password is only reserved for the technical staff members in charge of installation and maintenance operations.
PRIMARY PASSWORD (for the system's owner-user)
It is a 5-character password used by the user to prevent unauthorized persons from having access to N-DSEL programmer and change the
work program.
Using a primary password is optional and must be enabled by system's owner.
Default preset primary password is “A-A-A-A-A”.
WARNING!
When enabling the password, be careful not to forget the access combination.
SERVICE PASSWORD (for user)
It is a 5-character password that the system's owner may divulge to persons to be authorized to use N-DSEL programmer.
The service password only allows changing the automatic door work program.
Default preset service password is “A-A-A-A-A”.
To change the service password, it is necessary to have access by primary password.
Use the button to move the selection arrow downward, F2 button to move back upward.
HOW TO CHANGE THE PRIMARY PASSWORD
Ÿ
Select “PRIMARY PASSWORD”
Ÿ
Press OK (F1) button.
Ÿ
Type the default preset primary password “A-A-A-A-A” by pressing 5 times on A
button.
(IF the primary password is not the default password as it had already been
changed before, type the currently-used primary password).
Ÿ
Type the new primary password, selecting a combination of 5 characters from the
letters A-B-C-D.
