36
18.2)
ET-DSEL DIGITAL PROGRAMMER – USED AS PROGRAM SELECTOR
ET-DSEL digital programmer can be installed in the system and used by the user like a program selector, as an alternative to manual and
EV-MSEL mechanical selector if you need a more complete tools in terms of functions and graphs.
To enable ET-DSEL operation like a program selector, set up F01 function OFF (see “Functions setup” paragraph).
By pulse-pressing the button, choose the automatic door operating mode.
Each time a button is pressed, it switches from a work program to the next one.
The operating programs to be selected by button are described below.
Bi-directional automatic program
The door automatically opens when each opening control activates.
Single-direction automatic program output only
To exclude the incoming detection on external radar input
Single-direction automatic program input only
To exclude the outgoing detection on internal radar input.
Open door program
The door stops in complete opening position.
Night lock program
The door can only be open by OPEN input or radio control if EN/RF1 radio receiver is installed.
Free manual door
The automatic operation is disabled and door can be manually open.
Power warning light display
The symbol indicates the presence of mains power voltage and the battery, if any, is
operating.
Ÿ
The symbol indicates the absence of mains power voltage and operator activity is
ensured by emergency battery, if any, which is in working order.
Ÿ
The symbol with mains power voltage indicates that the battery is damaged.
In this case, the control unit buzzer emits a beep before each door opening for 10 cycles
(if F08 function OFF), or the door opens and remains open (if F08 function ON).
Ÿ
The symbol without mains power voltage indicates that the emergency battery is
about to run out.
