Roll the belt up around the motor pulley and pull it
·
Finally, cut the driving belt, insert it in the lower belt coupling bracket, and lock it by tightening the screws.
Adjust the belt tensioning by screwing the side screw of the idle pulley and, once the required tension has been
reached, tighten the front screw.
Apply, in the upper part of transom No. 10,
the black plastic cable glands (8) inserting them as per
figure, and place them at regular spacings along the
whole length of the transom.
12
29
30
31
32
33
34
23
30
29
31
32
33
34
Summary of Contents for EVOLUS
Page 2: ......
