38
P33
Motor thrust distance at closing end (active only with F38 = OFF)
At the default value 0%, the function is disabled.
Increasing the value increases the degrees from the end of the closing run in which the motor
thrust is enabled to facilitate the completion of the closing manoeuvre, in critical situations caused,
for example, by draughts.
At 100% of the value the motor is enabled throughout the closing phase.
The thrust power of the motor is regulated by the potentiometer P15.
S
P34
Parameter active if
F77 = ON
Adjustment of the time within which the user can activate door locking from inside once the door is
closed. At value "0" the time is set to infinite; therefore, it is always possible to activate door locking
through the internal touchless sensor. From value "1" to "100", the time is adjusted between 1 and
100 seconds (factory setting = 10 seconds).
Once this time period has expired, the maglock is not engaged and the touchless sensor will
activate door opening.
P35
Parameter active if
F77 = ON
Adjustment of the time after which the maglock is released automatically if the door has been
locked from inside. At value "0" (factory setting) the time is set to infinite; therefore, the maglock
keeps the door locked until the user activates the internal touchless sensor to open the door and
exit. From value "1" to "100", time is set from 1 to 100 minutes.
Once this time period is expired the traffic light flashes red/green, advising the user that door will
be unlocked within 3 minutes.
P36
Not used
P37
Not used
P38
Not used
P39
Not used
P40
Not used
P41
Not used
P42
Not used
P43
Slowdown ramp during opening
Increasing the value, leaf slowdown moves toward the last degrees of the opening cycle.
S
P44
Intensity of the braking during opening
Increasing the value increases door braking intensity during the opening cycle.
S
P45
Not used
P46
Not used
P47
Not used
P48
Scheduled maintenance
This parameter allows to select the number of opening/closing cycles after which the message
"SCHEDULED MAINTENANCE" appears on the display of the program selector.
The maintenance signal can also be displayed on the open collector output between the terminals
S-24 of the electronic control unit if the operating mode C is selected in the function F41m.
When set to OFF (default value), the scheduled maintenance message is never displayed.
Select the number of cycles after which maintenance is to be reported according to door operation
and to the usage conditions:
8K (8,000 cycles), 16K (16,000 cycles), 32K (32,000 cycles), 64K (64,000 cycles), 128K (128,000
cycles), 256K (256,000 cycles), 512K (512,000 cycles).
P49
Not used
P50
Not used
