Page 12
A) Sync Mode (FIG. 20
-
Bottom)
•
Sync Mode enables semi
-
automatic operation. Once the operator has chosen the desired direction and
speed, the machine will automatically adjust the speed throughout the counting process to optimize the
counting time and roll tension.
•
Place the
“
SYNC
”
switch in the up position, and the blue LED above the switch will illuminate to indicate
that Sync Mode has been activated.
•
While in Sync Mode,
the right side controls are deactivated
. Direction and max speed are set for
both
motors using the
“
LEFT/SYNC
”
switch and speed dial.
•
While in Sync Mode, rollers must unwind and rewind from the outside as shown in
FIG. 25
.
•
Set the
“
LEFT/SYNC
”
speed control to desired max speed
-
f
ull clockwise rotation for max speed, full
counter
-
clockwise rotation for no speed.
•
Set the
“
LEFT/SYNC
”
direction switch so the arrow is pointed in the desired flow direction (toward the
rewind side).
•
The machine will begin counting. You may notice it will speed up and slow down automatically through-
out the counting process. This is intentional as the machine is optimizing for tension and speed.
NOTE: DO NOT BLOCK THE RAISED SENSOR BOX LOCATED IN THE CENTER OF THE UNIT AS THIS WILL
CAUSE THE UNIT TO MALFUNCTION.
FIG. 24
FIG. 25
FIG. 26
