LM1012TTS Table-Top Label Applicator System
USER'S MANUAL
Made in the U.S.A.
© 2022 LABELMILL
01/01/2022 Model LM1012TTS
Page 10
WEB ROUTING
Step
Operation
1
Load web onto label storage spool (A) so it unloads in a clockwise direction.
2
Insert the web under the first guide roller and over the second guide roller (B).
3
Wrap the web around the peeler plate (C), continuing on to the drive roller (D).
4
Turn the Pinch Roller Knob (G) 180deg. to open the pinch roller from the drive roller.
5
Feed the web over the top drive roller (D). Next, slip the web between the drive roller
and the pinch roller (E). Continue on by wrapping the web under the drive roller.
6
Finish the process by loading the waste backing paper onto the web take-up spool (F).
The take-up spool rotates in a counter-clockwise direction.
7
Turn the Pinch Roller Knob (G) 180deg. so that the pinch roller and drive roller contact
each other. When the roller is closed, roll the knob back and forth between your fingers
so that you can feel a “flat” on the shaft.
NOTE: This must be done to ensure proper label feeding.
8
Adjust the plastic web guide clips so the web is guided straight and even. Make sure the
clips do not bind the web.
9
Lock the wiper assemblies near roller (B) and at the peeler plate (C) with light pressure
to keep proper tension the system and to assist in peeling the label from the liner.
** To remove the label storage spool (A), turn the spool lock counter-clockwise (approx. 15 deg.) until you reach a stop.
The spool will now slide off. To secure the spool, simply turn the spool lock clockwise until snug. DO NOT over tighten
the spool lock!
Pinch Roller Knob (G)
(A)
(B)
(C)
(G)
Spool Lock
(D)
(F)
(E)
