LM1012TTS Table-Top Label Applicator System
USER'S MANUAL
Made in the U.S.A.
© 2022 LABELMILL
01/01/2022 Model LM1012TTS
Page 12
Z-Z-ELS100 LABEL SENSOR SETUP INSTRUCTIONS
Teach Mode Setup Procedure:
1. Place the web liner in the sensor (remove a label or use the label gap).
Press the [+] and [-] buttons at the same time for less than one second.
The red LED will begin to flash.
2. Place the web liner,
with a label
, in the sensor.
Press the [-] button for less than one second.
The red LED will stop flashing.
3. The automatic setup is complete. (Steps 1 and 2 can be reversed)
Manual Sensitivity Adjustments:
The "Teach Mode Setup" should always be successful. However, the sensitivity can be adjusted manually by
pressing the [+] or [-] buttons. The red LED will flash with each button press.
Locking/Unlocking the Setup:
Press and hold the [+] and [-] buttons for three seconds (but less than six seconds). The red LED will
change state. When the buttons are released, the red LED will then indicate locked (red LED on) or unlocked
(red LED off).
Light/Dark Switching:
Press and hold the [+] and [-] buttons for six seconds. When the mode is changed, the red LED will begin to
flash slowly until the buttons are released.
