LM1012TTS Table-Top Label Applicator System
USER'S MANUAL
Made in the U.S.A.
© 2022 LABELMILL
01/01/2022 Model LM1012TTS
Page 21
LABEL SENSOR
Provides the ability to select different label sensor types and also set the parameters within these sensor types.
PROGRAMMABLE BLOCKS:
I-Mark/Gap/CLR
– Used to select type of label sensor. "Clear" used for standard applications.
Manual Set Gap
– Automatically sets the emitter voltage when sensor is held on gap between labels.
- Not used in systems manufactured after 2020.
Gap Threshold
– Voltage differential needed to trigger control. (sensitivity)
Label Stop Position
– Electronically adjusts label stop position in reference to the peeler plate point.
Missing Label Detect - Turns on the missing label alarms and enables the auto advance feature.
Label Length - Used to program the length of the label being used.
Label Gap Length - Used to program the length of the gap between each label.
COUNTER
Used to reset the internal Total Counter or Batch Counter of the control.
CYCLE TYPE
Cycle Type determines the application type and sequence in relation to the label feed.
PROGRAMMABLE BLOCKS:
No Tamp
Tamp Before Feed
Tamp After Feed
Blow Before Feed
Blow After Feed
Clam Shell Before
Clam Shell After
Round Module
Auto Round Module
PRINTER SETUP
Used to control the system operation when an external printer is connected to the applicator.
Printer - On/Off
Reprint - On/Off
Printer Ready - Enable or Disable monitoring of Printer Ready Signal.
Printer Ready Fault Timer - Programmable timer for monitor of End of Print Signal & Fault Output.
Print a Label - Signals External Printer to print a single label.
Cycle with No Print - Cycles the applicator system without signaling the printer to print a label
Clear Label Buffer - Clears the printer buffer of the external printer (Doesn't work w/ all printer models)
JOB STORAGE
Used to store frequently used settings pertaining to different labeling jobs.
PROGRAMMABLE BLOCKS:
Job Status
– Displays if jobs are filled or empty (1-6)
Read a Job
– Restores saved job (1-6)
Write a Job - Saves settings to specified job (1-6)
Delete a Job - Deletes the saved job file (1-6)
Delete All Jobs - Deletes all saved job files
DEFAULT SETTINGS
Selecting this option will return the controller to the factory default settings.
