LM1012TTS Table-Top Label Applicator System
USER'S MANUAL
Made in the U.S.A.
© 2022 LABELMILL
01/01/2022 Model LM1012TTS
Page 32
KEY DEFINITIONS
ASYNCHRONOUS OPERATION
– The term “ASYNCHRONOUS OPERATION” is used because the speed of the
applicator motor (label speed) does not necessarily match the speed of the product conveyor. In other words their
speeds are set independently of one another and have NO interrelation. An example of this is when the applicator is
configured in the tamp mode.
SYNCHRONOUS OPERATION
– The term “SYNCHRONOUS OPERATION” is used because the speed of the
applicator motor (label speed) is matched to the speed of the product conveyor.
PRODUCT DELAY is used to electronically move the placement of the label on a moving product. Product delay will
move the label placement in time (00.000) seconds. Because the product delay feature utilizes time, the speed of the
product MUST remain constant. A product traveling at a higher velocity will travel further in a given time, thus effecting
the placement of the label.
QUICK START GENERAL SETUP
1.
Inspect applicator system and verify all cables are installed properly.
2.
Web system with labels.
3.
Turn power switch on.
4.
Press “PROG” key to enter setup menu.
5.
Use up or down arrows to reach "CYCLE TYPE" menu.
6.
Press “ENTER” key on "CYCLE TYPE"
7.
Select "No Tamp" option and press "ENTER" key to save.
8.
Use up or down arrows to reach "LABEL SENSOR" menu, and press "ENTER" key.
9.
Use up or down arrows to reach "I-MARK / GAP / CLEAR" menu, and press "ENTER" key.
10.
Use up or down arrows to reach "CLEAR" option, and press "ENTER" key.
11.
Press "PROG" key to exit the programming menu and return to main screen.
12.
Cycle system twice by pressing the “START” key.
13.
Observe label speed and change if required.
14.
Manually move the label sensor if needed so that the label stops flush with the peeler plate tip.
System is now ready for set up of advanced features & options.
