LM1012TTS Table-Top Label Applicator System
USER'S MANUAL
Made in the U.S.A.
© 2022 LABELMILL
01/01/2022 Model LM1012TTS
Page 34
HOW TO SET UP AN ASYNCHRONOUS APPLICATION
TAMP SETUP
Determine the following and select it in the software
1.
Type of application mode -
MENU “CYCLE TYPE”
2.
Tamp before or after feed (before feed is standard)
3.
Enter a value in the tamp duration (start with 00.200) - MENU "TAMP SETUP"
4.
Set head up limit switch, normally open is standard - MENU "TAMP SETUP"
5.
Set Label Speed to appropriate value - MENU "LABEL SPEED"
6.
Adjust position of Label Sensor so that label stops at edge of peeler plate.
FLAG SETUP
Determine the following and select it in the software
1.
Type of application mode -
MENU “CYCLE TYPE”
2.
Tamp before or after feed (before feed is standard)
3.
Enter a value in the tamp duration (start with 00.200) - MENU "TAMP SETUP"
4.
Enter a value in the flag duration (start with 00.200) - MENU "TAMP SETUP"
5.
Set head up limit switch, normally open is standard - MENU "TAMP SETUP"
6.
Set Label Speed to appropriate value - MENU "LABEL SPEED"
7.
Adjust position of Label Sensor so that label stops at edge of peeler plate.
BLOW SETUP
Determine the following and select it in the software
1.
Type of application mode -
MENU “CYCLE TYPE”
2.
Blow before or after feed (before feed is standard)
3.
Enter a value in the tamp duration (start with 00.100) - MENU "TAMP SETUP"
4.
Set head up limit switch, NONE is standard - MENU "TAMP SETUP"
5.
Set Label Speed to appropriate value - MENU "LABEL SPEED"
6.
Adjust position of Label Sensor so that label stops at edge of peeler plate.
CLAMSHELL FLAG SETUP
Determine the following and select it in the software
1.
Type of application mode -
MENU “CYCLE TYPE”
2.
Clamshell before or after feed (before feed is standard)
3.
Enter a value in the tamp duration (start with 00.200) - MENU "TAMP SETUP"
4.
Enter a value in the flag duration (start with 00.200) - MENU "TAMP SETUP"
5.
Set head up limit switch, normally open is standard - MENU "TAMP SETUP"
6.
Set Label Speed to appropriate value - MENU "LABEL SPEED"
7.
Adjust position of Label Sensor so that label stops at edge of peeler plate.
