LM1012TTS Table-Top Label Applicator System
USER'S MANUAL
Made in the U.S.A.
© 2022 LABELMILL
01/01/2022 Model LM1012TTS
Page 42
Flag Module Setup
Label jaw adjustment
1. To adjust the label jaws (J) in relationship to the peeler plate (P) in the horizontal plain, loosen the thumbscrews (S) and
move the flag module forward or backward in the slots. There should be approximately .020" (A) gap between the label
jaws (J) and the peeler plate (P). The jaws (J) can also be adjusted left to right in relation to the peeler plate (P) via the
slot in the top of the crossbar (D).
NOTE:
The center of the jaws should be at the center of the label.
2. To adjust the label jaws (J) in relationship to the peeler plate (P) in the vertical position, loosen the mounting screw (M)
and adjust the vertical screws (V) in or out to achieve the .020" (B).
NOTE:
The label jaws (J) must maintain parallelism
with the peeler plate (P).
Air assist tube adjustment
1. Adjust the air assist tube (B) so that the small holes aim towards the center of the label as shown by the arrowhead (F)
shown above. The air assist tube (B) aids the label (L) to adhere to the bottom of the label jaws (J). Once the label (L) is
“blown” onto the label jaws (J), it is held there by vacuum.
2. Once the above adjustments are made, adjust the vacuum regulator, the air assist regulator, and the flow controls as
needed.
Note: Too much pressure on the air assist will cause the label to flutter and/or blow off of the vacuum platen.
Rail (C)
Mounting Screw (M)
Vertical Set Screw (V)
Thumbscrew (S)
Crossbar (D)
Air Assist Tube (B)
Peeler Plate (P)
Label Jaws (J)
Label (L)
Airflow (F)
