LM1012TTS Table-Top Label Applicator System
USER'S MANUAL
Made in the U.S.A.
© 2022 LABELMILL
01/01/2022 Model LM1012TTS
Page 45
Auto Round System Module Installation
The Auto Round System Module shown below can be installed in a few minutes to the existing LM1012 system
dispenser unit.
ACTIONS TO INSTALL AUTO ROUND SYSTEM
1. Set the main power switch to the OFF position.
2. Disconnect the AC power cable from the rear of the console.
3. Remove any installed module or photo-eye mounted to the guide rails.
4. Carefully slide the auto round system module onto the rails until the unit is in the proper position.
5. Install and tighten the mounting knobs through the slotted holes on either side of the mounting rails.
6. Install the cable from the auto round system module into the connector on the accessory panel.
7. Install the cable from the auto round system module limit switch into the connector on the accessory panel of the control
box tagged “HEAD UP/AUX”.
8. Install the cable
into the connector on the accessory panel of the control box tagged “REMOTE TRIGGER” (Foot Switch,
Palm Button, or Trigger Switch).
9. Adjust the product in feed chute so that the product rolls freely into the take-up wheel.
10. Adjust the take-up wheel with the product under the yellow roller. When the product is indexed to the position under the
roller, the roller should be lifted enough to open the limit switch and trigger the LM1012TTS to label the product.
11. Connect the power cable and turn it on.
12. Program the
control Cycle Type for “Auto Round”.
13. Adjust the label sensor, and label speed until both are functioning properly.
14. The label feed speed should match to the roller motor speed. If the label motor speed is too fast, the label will bunch up.
If it is too slow the product will pull the web.
