LM1012TTS Table-Top Label Applicator System
USER'S MANUAL
Made in the U.S.A.
© 2022 LABELMILL
01/01/2022 Model LM1012TTS
Page 7
USER RESPONSIBILITY
This equipment will perform in conformity with the description thereof contained in this manual and accompanying labels
and/or inserts when installed, operated, maintained, and repaired in accordance with the instructions provided. This
equipment must be checked periodically. Defective equipment should not be used. Parts that are broken, missing,
plainly worn, distorted, or contaminated should be replaced immediately. Should such repair or replacement become
necessary, we recommend that a request for service advice be made.
This equipment or any of its parts should not be altered without the prior written approval of LABELMILL. The user of
this equipment shall have the sole responsibility for any malfunctions which results from improper use, faulty
maintenance, damage, improper repair or alteration by anyone other than LABELMILL or a service facility designated by
LABELMILL.
SAFETY
Only qualified personnel should use this equipment.
Before installing, inspecting or servicing equipment, turn OFF all power and air controls at the source and lock out in
accordance with OSHA Standards.
Be sure all external electrically conductive parts are connected to a good electrical ground.
Never handle live electrical equipment with bare hands while standing in water, or while hands and feet are wet.
Dangerous electrical shock can result.
Whenever the equipment is unattended, turn off all control and power supply switches.
Keep equipment clean and in good operating condition. Promptly repair or replace all worn or damaged hoses, cables
or parts.
Do not make any repairs to equipment unless you are fully qualified.
This equipment contains fast moving parts that may move without warning. Keep hands, loose hair and clothes clear of
machines at all times.
Never place hands or any other body parts under the label platen at any time.
This equipment uses compressed air. Proper care and maintenance must be taken when handling compressed air and
its components.
These precautions are further detailed and explained where specifically required in this manual.
WARNING
READ AND UNDERSTAND THESE INSTRUCTIONS
Protect yourself and others. Be sure this information is read and understood by all operators.
ELECTRICAL SHOCK CAN KILL!
Do not touch live electrical parts with bare skin or work with gloves or wet clothing.
NOISE CAN DAMAGE HEARING!
Wear proper ear protection.
