Labgear Reserve the right to modify their designs or specifications, In the light of future
developments, without prior notice. Performance figures quoted are typical and subject to
normal manufacturing and service tolerances.
This product is intended for use within the UK and Eire.
Declaration of Conformity
Hereby, Labgear declares that this amplifier for TV broadcast reception in domestic premises is in
compliance with the Radio Equipment Directive 2014/53/EU.
The full Declaration of Conformity is available by contacting the following internet address:
www.labgear.co.uk/DoC
2 –Year Guarantee
Your amplifier is guaranteed against faulty components or poor
workmanship for a period of two years from the date of purchase.
This guarantee does not cover accidental or malicious damage
(Including damage from natural causes such as lightning) and will be
invalidated by installation or use other than in accordance with these
instructions, repair or attempted repair other than by the manufacturer, or
opening or removal of the case. This does not affect your statutory rights.
4
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority for
recycling advice.
© Philex Electronic Ltd. 2017 V1
COMPLIANT
Technical Support
For further help, advice or information visit
Our website www.labgear.co.uk
Email: technical@labgear.co.uk
or
live chat
during office hours via our website
Member
No. M. 1125
Bedford MK42 0NX
www.labgear.co.uk
Guarantee and Technical Support
Signal connections
Input and output connections to the amp are
made using F-type (IEC 60169-24) connectors.
Connections can be made using a tool for
crimp or compression connectors or by hand
with twist-on connectors (see Fig.1 opposite).
Ensure that the correct size connector is used
to match the size of the coax cable.
Make sure that the external connections are
adequately weatherproofed to prevent water
ingress which could damage your amplifier.
8mm
6mm
2mm approx.
fold braid back
over sheath
inner wire
cut or tear
away foil
screw connector
body onto cable
end of insulation
should be flush
with this face
Fig. 1
