Operation
The power supply should be connected with the corresponding socket.
The red LED illuminates when the device is connected with the power supply
system.
The handpieces should be connected with the corresponding socket.
Switch on the device with the on-off button; the power LED is off. Press it again to
switch the device off.
The welcome screen will appear on the display; it can be skipped with every
button.
The handpiece can be chosen. It is shown on the display.
The speed is shown on the display.
By pressing plus or minus, the speed can be altered.
The GO button switches the handpiece on.
The green LED illuminates to show that a handpiece is in operation.
The laserhandpiece should be connected with the corresponding socket.
The laser button activates the stand-by mode of the laser handpiece.
The start button switches the laserhandpiece on.
The yellow LED illuminates to show that the laserhandpiece is in operation.
The foot pedal should be connected with the corresponding socket.
The handpiece will be switched on and off by pressing the foot pedal.
Control unit
Start-up
The device is designed to be used on a table, i.e. it has to be placed on a firm and level
surface.
The clearly marked connecting sockets for the mains power supply and the handpiece are
at the rear of the appliance. The appliance is ready for operation when it is connected to
the power supply unit and thus the mains. This is indicated by a red light.
During breaks, the handpiece must only be placed onto the holder which should
be covered with a protective film.
Only use the device with the power supply as specified on the device’s rating plate. The
mains voltage must be the same as the rated voltage of the device as printed on the power
supply.
The device is only designed for internal use. It can be operated without impairment at
room temperatures ranging from 10 °C to 35 °C. Please make sure prior to using the de-
vice that it has adapted to room temperature; otherwise, condensation could damage the
electronics (a temperature differential of 10 °C requires a minimum three hour).
Safe operation cannot be guaranteed:
• If the device or its accessories show signs of damage,
• if the device does not work properly,
• after longer-term storage outside of the prescribed temperature range,
• in cases of transport damage if the device has been improperly transported.
In these cases the device should always be returned to the authorized specialist dealer/
supplier for inspection.
3
7
1
4
11
6
8
9
Operating Manual
7
6
5
12
9
2
10
