Hygiene module
For the use of the hygiene module the chapters “important hygiene and safety instructions” have to be con-
sidered.
A label attached to each module states the batch
number, as well as the production and expiration
dates. The batch number enables the identifica-
tion of the precise batch and has to be communi-
cated to the manufacturer in case of issues. This
number has to be noted in the customer file. The
manufacturer guarantees the sterility for 5 years if
the packaging is closed and undamaged and if the
conditions in the chapter “Shipment and storage
requirements” are met. The modules have to be
stored in the original packaging.
Utilisation of pigments
The module must be filled with 2 to 3 drops of colour. Alternatively, the tip of the module can be immersed
into the colour for 2 to 3 seconds. The colour is sucked in when the device is switched on. Contact with the
paint container must be avoided.
Adjustment of needle stand-out
The adjustment of the penetration depth must be performed while the device is switched on. In order to
adjust the stand-out of the needle, the handpiece has to be hold at the rear section of the pen. The needle
can be adjusted individually by screwing the front section of the hygiene module with the second hand.
The correct stand-out of the needle depends on the respective treatment, the skin type, the desired effect
and other factors. This know-how is gained during training.
7
