HOW TO USE THE AMPLIFIER IN ORDER TO PROLONG TUBES’ LIFE-SPAN
1). The amplifier should always be switched on in the following way: first turn
Power
on and wait
for 1 minute. Then, you can turn the
Standby.
Switching the amplifier off is the other way
around – first turn
Standby
off, then wait 1 minute, then you can turn power off.
2). Always use a matched quartet of power tubes, from Laboga or renowned producers.
3). Before transporting the amplifier, wait for the amplifier, especially for the tubes, to cool down.
4). When you don’t use the amplifier, it is advisable to regulate
Standby
to position “0”
5). An excessive amount of dust on the tubes may decrease heat distribution of the tubes, which
could shorten tubes’ life-span. Use an original Laboga cover or hard case to prevent damage
and dust.
TECHNICAL DATA
INPUTS:
Guitar input sensitivity:: -10 dBV
Maximum signal level: +4 dBV
Input impedance: 1 MΩ
OUTPUTS:
Power output impedance:
- 4 Ω output impedance
- 8 Ω output impedance
- 16Ω output impedance
Output power: 30W / 15W (rms)
Balanced line signal level output: -3 dBV
EFFECTS LOOP:
Effects Loop
Send
output level:
0 dBV
Effects Loop
Send
output impedance:
100 Ω
Effects Loop
Return
output level:
0 dBV
Effects Loop
Return
output impedance: 470 kΩ
TUBES:
Preamp section: two 12AX7
Power section: four EL84M
POWER SUPLY:
230V AC / 50Hz – mains fuse: SloBlo T1,6A/250V
110V AC / 60Hz – mains fuse: SloBlo T3,15A/250V
Maximum power consumption: 184 VA
CASE:
Alligator AD5200
Dimensions: 670 x 275 x 250
Weight: 21 kg
Alligator AD5201
Dimensions: 490 x 270 x 450
Weight: 29 kg
Alligator AD5202
Dimensions: 670 x 278 x 515
Weight: 37 kg
Page
15
