2
Luxeo
4140000-795
Luxeo
Issue 1.3
Printed on Jan.,2020
SAFETY INFORMATION
2
SAFETY SYMBOLS
The following symbols are found on the microscope. For optimal use, it is recommended that users
Understand these symbols and always use the equipment as prescribed.
Symbol
Explanation
This surface has a tendency to heat up and should not be touched unless
System has completely cooled down.
Before use, carefully read the instruction manual. Improper use could result in
Injury to the user and/or damage to the equipment.
Main switch is ON.
Warning against risk of electric shock.
Main switch is OFF
.
|
!
1. After the microscope has been used for observation of a specimen containing bacteria, clean
all parts coming in contact with the specimen to prevent infection.
•
Be sure to remove the specimen before moving this product.
•
In case the specimen is damaged by erroneous operation, it is important to clean all surfaces that
may have come in contact with the specimen.
2. To avoid potential electrical hazards while replacing either LED, turn the microscope main switch to
the OFF position and disconnect power cord from wall outlet in advance.
Whenever you replace your microscope LED, allow lamp socket and LED to cool before touching
(Fig.1)
Applicable LED cluster replacement for incident illumination
Applicable LED cluster replacement for transmitted illumination
3. Install microscope on a sturdy, level table or bench and avoid any restriction of air vents in the
base of the unit.
Do not place microscope on a flexible surface, as this could result in blocking the air vents and cause
Overheating.
4. Always use the power cord provided by LABOMED. If the proper power cord is not used, product safety
performance cannot be warranted.
5. When installing the microscope, route the power cord away from the microscope frame. Should the
power cord come in contact with the microscopes base, the power cord could melt due to overexposure
to heat.
6. Always ensure that the grounding terminal of the microscope and that of the wall outlet are properly
connected. If the unit is not grounded, LABOMED can not warrant electrical safety.
7. Never allow metallic objects to penetrate the air vents of the microscope frame as this could result in
user injury and damage to the microscope.
8. After operation of microscope, be sure to disconnect power cord from connector socket of the microscope
or from the wall power outlet.
