Fig. 12
Fig. 13
Fig.14
1
Lx 400
Lx 400
Lx 400
Objectives are factory set. Objectives are par-centered and parfo-
calised during assembly.
All objectives have been secured for a tight fit to prevent them
from coming loose during transit. To remove an objective, rotate it
counterclockwise while holding it with a rubber grip to avoid any
slippage.
Install the observation head using the following procedure:
1. Using allen wrench 3mm (provided), loosen the Head Locking
Screw (1) and remove the dust cover cap provided in dovetail
cavity as well as on observation head dovetail.
2. Mount the Observation Head by engaging the dovetail provided
at the bottom of the head into the dovetail cavity provided in
the microscopes arm.
3. Tighten the Head Locking Screw (1) after positioning the Obser-
vation head as desired. See figure 13.
Insert the eyepieces into the ocular tube of Observation Head
using following procedure:
1. Remove the protective caps from the observation tube.
2. Insert 10x eyepieces into the ocular sleeve and tighten the
clamping screw (1) using allen wrench 1.2mm. See figure 14.
Lx 400
INITIAL SETUP
8
OBJECTIVES
1
OBSERVATION HEAD
2
EYEPIECES
3
12
9126000-795
Lx 400
Issue 1.5
Printed on April,2019
