INITIAL SETUP
9
1
2
Observation Head
Eyepieces
Install the observation head using the following procedure:
1. Using the 3mm allen wrench (provided), loosen the Head Locking
Screw (1) and remove the dust cover cap provided in the dovetail
cavity.
2. Mount the Analyzer attachment by engaging the dovetail provided on
the attachment into the dovetail cavity on the microscope arm and
tighten the Head Locking Screw (1) See figure 15.
3. Remove the Dust Cover Cap from Observation Head Dovetail and
mount the Observation Head by engaging the dovetail provided at the
bottom of the head into the dovetail cavity on the analyzer attachment.
4. Tighten the Head Locking Screw (2) after positioning the Observation
Head as desired. See figure15.
Fig.15
Fig.16
Insert the eyepieces into the ocular tube of Observation Head using the
following procedure:
1.
Remove the protective caps from the observation tube
(See figure16).
2.
Insert eyepieces into the ocular sleeve for use (See figure17).
1
2
15
Lx POL
Fig.17
