146
Nexam Pro User Manual
Chapter 9
9.5.1
Insert Channel Markers
The channel markers should be inserted on the channels on which the specific
test is registered. The results will then be calculated on these channels.
When
you open the investigation for the first time, the
anorectal manometry
channel marker settings
dialog window will display automatically.
Figure 9.21
Example of anorectal manometry channel marker settings
When you performed the investigation with, for instance a spiral catheter, you
need to decide on which channel(s) you want to perform analysis for each test.
After you set this, you can save the settings as default. For the next
investigation (if performed with the same catheter and in the same way), you
can use these settings again.
When you performed the investigation with a radial catheter, you select all
channels for all tests.
It is always possible to change the settings (i.e., after you reviewed the curves
and decide that the settings must be changed). Choose
Settings > Anorectal
manometry channel marker settings
to display the settings dialog.
9.5.2
Channel Definition
In the channel definition window, you can define which pressure channels you
want to analyze. Choose
Settings > Channel definition
or click the
Channel
definition
button to display the dialog box shown in Figure 9.22.
Summary of Contents for Nexam Pro CIM
Page 1: ...Nexam Pro User Manual...