7
Installing
Installing
Installing
Installing Steps
Steps
Steps
Steps
:
1) Wall-mounting Part installation: Locate the height and position of the electronic whiteboard
to be installed, and mark the holes position of the wall-mounting pieces on the wall as shown
in the picture below.
（
See
Figure 3-1
）
Installing
Installing
Installing
Installing Tips:
Tips:
Tips:
Tips:
The length from the knob of the wall-mounting piece to the lower frame of the whiteboard is
95cm. The recommended height from the ground to the lower frame of the interactive
electronic whiteboard shall be around 75-80 cm.
2) Drill holes in the four marked spots with a diameter of 8mm drill and fix two wall-mounting
pieces by using 6*70 expansion screws.;
3) Fix two pieces of supports onto the lower frame of the back of whiteboard, as shown below;
4) Fix the Link knob into the wall-mounting pieces, see attached picture above.
5) Mark the position of holes in the Support after successfully hanging the whiteboard on the
wall,
lay flat the whiteboard on the package carton, drill holes in the marked two spots with a
diameter of 8mm drill and fix the support by using 6*70 expansion screws.
Caution:
Caution:
Caution:
Caution:
Set up this product on a level floor surface with a weight bearing capacity of 120 kg/m2
or more, and which is made of floor materials that will not deform or become depressed due to
movement by casters.
Figure
Figure
Figure
Figure 3-1
3-1
3-1
3-1
Figure
Figure
Figure
Figure 3-
3-
3-
3-2
222
