5
STARTING
There are no compressor shipping bolts to loosen or valves to open. All that is necessary
after the unit has been properly leveled is to plug the service cord into an electrical outlet
When starting this new appliance, allow the cabinet to operate a minimum of eight hours or
until it has started cycling normally before placing product in the cabinet. The motor
compressor may start and stop several times when the unit is first started or after
defrosting, especially if the weather is very hot. This is only normal functioning of the
motor overload protector. The motor compressor will cycle normally as soon as the excess
heat has been removed.
TEMPERATURE CONTROL
NOTE:
The control is preset at the factory to provide the desired air and
product temperatures inside of the unit and requires no further
adjustment. Please contact the manufacturer’s Technical
Support Department before making any adjustments to
determine if adjustment is necessary and, if so, to make sure it is
performed properly.
This unit has a manual thermostat which controls the compressor. It is located inside the
compartment. Turning the thermostat towards the “COLDER” arrow will make the unit
colder. Turning the thermostat towards “WARMER” arrow will make the unit warmer.
Turning the thermostat to the off will turn the unit off.
