1-13
GENERAL MAINTENANCE
WARNING
CAUTION
CAUTION
BEFORE DOING ANY
MAINTENANCE ON THE VEHICLE,
ALL SAFETY REGULATIONS
MENTIONED IN THE OPERATOR
MANUAL, SECTION 2.0, MUST BE
RESPECTED, ESPECIALLY THE
“LOCKOUT/TAGOUT”
PROCEDURE (ANSI Z 245.1 1999).
MAINTENANCE PERSONNEL
SHALL NOT DO ANY
MAINTENANCE ON THE
EQUIPMENT IF THEY ARE NOT
WELL ACQUAINTED WITH THE
OPERATIONS OF THE EQUIPMENT
AS WELL AS ALL SAFETY
PRECAUTIONS OF SUCH
OPERATIONS. REFER TO THE
OPERATOR MANUAL BEFORE
ATTEMPTING TO PERFORM ANY
TYPE OF WORK ON THE UNIT.
MAINTENANCE AND REPAIRS
CARRIED OUT ON THIS VEHICLE
MUST ONLY BE DONE BY
QUALIFIED PERSONNEL WHO IS
FAMILIAR WITH THE EQUIPMENT.
LABRIE EQUIPMENT DECLINES
ANY RESPONSIBILITY FOR
FAILURES RESULTING UNPROPER
REPAIRS PERFORMED BY THE
END USER.
1.3
GENERAL RESPONSIBILITIES
OF THE EMPLOYEE
1. The employee must enforce all of the
safety requirements for mobile
equipment supplied by the employer.
2. Equipment is to be operated only after
having received instructions and training
in accordance to Operator Manual.
3. The employee has the responsibility to
report any damages or malfunctions of
the vehicle to his employer or his
supervisor without any delay. The
employer will then take the necessary
measures prior to the re-operation of
the vehicle to insure its safe operation.
4. The employee must make sure that
there is nobody near the vehicle before
activating any of the controls and must
be prepared to stop anything in case of
danger.
Summary of Contents for Automizer Versa Hand
